Ashok B. Gadkari; Tukaram J. Shinde; Appaso A. Wali; Pramod N. Vasambekar
Abstract
Nanocrystallite ferrites samples with general formula Mg1-xCdx Fe2O4 (x = 0, 0.2, 0.4, 0.6, 0.8, 1) were prepared by oxalate co-precipitation method from high purity sulphates. The samples were characterized by XRD, SEM and FT-IR techniques. The phase identification of powder reveals single phase cubic ...
Read More
Nanocrystallite ferrites samples with general formula Mg1-xCdx Fe2O4 (x = 0, 0.2, 0.4, 0.6, 0.8, 1) were prepared by oxalate co-precipitation method from high purity sulphates. The samples were characterized by XRD, SEM and FT-IR techniques. The phase identification of powder reveals single phase cubic spinel nature of materials. The gas sensing properties were studied for ethanol (C2H5OH), liquid petroleum gas (LPG) and chlorine (Cl2). The MgFe2O4 is sensitive to LPG (~ 80%) followed by Cl2 (~75%) and less to ethanol (~ 58%) at an operating temperature of 225oC. The sample with x = 0.4 has highest sensitivity at operating temperature 225oC for LPG (~ 78%). It shows good sensitivity at operating temperature at 198oC for Cl2 (~75%) and ethanol (~ 65%). The CdFe2O4 sensor (x=1) exhibits very high sensitivity (85%) and good selectivity to ethanol than other tested gases such as LPG (~ 35%) and Cl2 (~ 30%). The response and recovery time decreases with increase in Cd2+ content for LPG, Cl2 and ethanol. The shorter response is observed to CdFe2O4 for LPG, Cl2 and ethanol.
Sitakshi Gupta; Chhaya Ravikant
Abstract
Nowadays, gas sensors are fast becoming an imperative part of modern life with extensive applications in domestic safety, environmental monitoring, industrial process control, public security, medical applications and chemical warfare assessment amongst many others. The detection of minor gas leaks has ...
Read More
Nowadays, gas sensors are fast becoming an imperative part of modern life with extensive applications in domestic safety, environmental monitoring, industrial process control, public security, medical applications and chemical warfare assessment amongst many others. The detection of minor gas leaks has been a challenging area of research, particularly in view of the hazards to human health and safety posed by toxic gases like NO2, NO, CO, NH3 etc and combustible gases like methane, hydrogen gas and some volatile organic compounds. Thus it is imperative to evolve and employ simple yet reliable gas sensing mechanisms with optimum response and selectivity towards even low concentration of analyte gas at room temperature. Most of the conventional gas sensors are based on metal-oxide semiconductors which are low-cost, exhibit good sensitivity and fast response/recovery. Zinc oxide is one such n-type semiconducting oxide, which has been widely studied for gas sensing response due to its ease of fabrication, high sensitivity and environment-friendly nature. However, the operating temperature of such sensors is usually high (>200°C) owing to the wide band-gap (3.37 eV) and high electrical resistance (kΩ-MΩ), which limits their practical utilization. In order to be used in hazard monitoring and home/workplace safety, the gas sensors need to be sensitive to gas exposure in mild operating conditions. As an alternative, more recently, graphene and its derivatives like pristine graphene (PG), reduced graphene oxide (rGO) etc. have been studied for sensing applications owing to their exceptional electronic and physical properties such as high carrier mobility at room temperature, good thermal stability, high mechanical strength, ballistic conductivity and large specific surface area. These sensors show high sensitivity at low operating temperatures (down to room temperature) towards low concentrations of analyte gas. However most of these rGO based sensors exhibit relatively longer response/recovery times than metal-oxide based gas sensors. Hence, nanocomposites formed by hybridizing graphene or its derivatives with metal-oxide nanoparticles are being explored as gas sensing materials. Combining reduced graphene oxide with zinc oxide to form hybrid nanostructures is particularly interesting because not only do they display the individual properties of the metal oxide NPs (faster response/recovery times) and of graphene (high electronic conductivity leading to efficient room temperature gas response), but may also have synergistic effects leading to better sensitivity as a gas sensing material. Here we present a review of the recent progress in rGO-ZnO nanocomposites based gas sensors. Copyright © 2018 VBRI Press.
